A few words about the building .....
read the whole manual before construction
I leave the material to the customer's choice.
I've found that if I recommend PETG, for example, not everyone can print it out nicely. ABS does not hold on another bed.
The model is designed so that if you choose your favorite material it will print without any problems. I have already printed them from PETG, ABS, PLA, CPE.
Choose a material best for your printer and has beautiful layers.
I recommend a layer of 0.2 mm, just 20% fill. For bearings use and caradans use min 75% infill.
For tires 5%
But if your printers combine layers, take advantage of it. Alternatively, if you want a very detailed surface, print on a 0.1 mm layer.
You need :
- contains 20 bearings 10x15x4
- screws M3 x 10 mm - 50 pcs
- screws M3 x 14 mm - 20pcs
- screws M3 x 16 mm - 20pcs
- screws M3 x 40 mm - 6pcs
- locking screws M3 x 6 mm (coils) - 50pcs
- screws M6 x 12 mm - 10pcs
- screws M6 x 10 mm - 5pcs
- Servo 360° 20kg -https://www.bighobby.cz/JX-servo-PDI-6221MG-360-digital-62g-20kg-d2556.htm
- Servo 20kg https://www.bighobby.cz/JX-servo-PS-5521MG-analog-55g-0-16sec-20kg-d1303.htm
- Motor 55T or more https://htmodel.sk/elektromotor-robitronic-razer-540-55t-brushed/
- Motor for reel https://htmodel.sk/motor-s-prevodovkou-nahradny-pre-navijak-elektricky-1-10-tfl/
- Batery for RC model https://htmodel.sk/akumulator-foxy-g3-li-pol-1300mah-7-4v-40-80c-9-6wh/
- Regulator for engine https://htmodel.sk/esc-regulator-konect-40a-waterproof/
- Regulato for reel https://htmodel.sk/regulator-dsys-dde6a-6a-univerzalny-pre-auta-lode-lietadla/